Abstract
In order to improve the dynamic performance of cam mechanism with high clearance. The two-state impact sub-model is used to simulate the gap between the cam and the follower to construct the dynamic model of the gripping cam mechanism considering the damping. The finite difference method is used to solve the dynamic equation with the cycloidal cam curve as the excitation function. The time domain and frequency domain analysis of the gap dynamics model are carried out, and the corresponding acceleration time domain and frequency domain response map are drawn. The influence of the damping ratio and the cycle ratio on the dynamic response is obtained. Then, several high speed cam curves are kinetics analysis. It is concluded that the existence of the gap will lead to the deterioration of the response accuracy of the system. The effect of the gap on the accelerating section of the follower is small, which has a great influence on the deceleration and deceleration period. The application of traditional theory in gap dynamics is limited.
Publication Date
9-28-2017
First Page
84
Last Page
89,93
DOI
10.13652/j.issn.1003-5788.2017.09.018
Recommended Citation
Xueming, HE; Kai, HE; Meiping, WU; and Xiaogang, JI
(2017)
"Dynamic analysis of high speed cam mechanism with clearance based on impact model,"
Food and Machinery: Vol. 33:
Iss.
9, Article 18.
DOI: 10.13652/j.issn.1003-5788.2017.09.018
Available at:
https://www.ifoodmm.cn/journal/vol33/iss9/18
References
[1] 周文玲, 刘安静. 洗瓶机出瓶机构的设计分析[J]. 食品与机械, 2007, 23(2): 80-82.
[2] 余剑武, 舒新, 罗红, 等. 灌装机中弧面凸轮建模与造型研究[J]. 食品与机械, 2016, 32(6): 77-82.
[3] 韩炬, 王莹, 郭亚楠. 包装机热封机构的建模及动力学分析[J]. 食品与机械, 2013, 29(1): 146-148.
[4] SENEVIRANTNE L D, EARLS S W E. Chaotic behavior exhibited during contact loss in a clearance joint of a four-bar mechanism[J]. MMT, 1992, 27(3): 307-321.
[5] 郭杏林, 赵子坤. 含间隙柔性曲柄摇杆机构动力学分析[J]. 机械强度, 2010, 32(6): 905-909.
[6] 王国庆, 刘宏昭, 何长安. 含间隙连杆机构非线性行为研究[J]. 机械设计, 2005, 22(3): 12-34.
[7] KOSTER M P. Effect of flexibility of driving shaft on the dynamic behavior of a cam mechanism[J]. Journal of Engineering for Industry, 1975, 97(2): 595-602.
[8] 常宗瑜, 张策, 王玉新. 含间隙机械系统动力学响应的特征[J]. 机械科学与技术, 2000, 19(3): 353-358.
[9] CHANG Zong-yu, LI Hua-jun. Dynamic response of deep groove ball bearing with point defects[J]. MMT, 2002, 12(2): 101-125.
[10] 张策. 机械动力学[M]. 北京: 高等教育出版社, 2008: 224-265.