Abstract
Objective： This study aimed to obtain suitable turbulence model for simulation infrared combined spouted bed numerical valued. Methods: Two equation models (SST k-ε and Realizable k-ε) were used for numerical simulation to obtain the performance parameters of the infrared spouted bed and the velocity, temperature and particle concentration distribution of the flow field in the drying chamber under different working conditions. The particle drying experiment of the infrared spouted bed was carried out. Results: When under the working conditions of air inlet velocity of infrared spouted bed drying chamber of 8 m/s and a temperature of 50 ℃, the values obtained by Realizable k-ε simulation are similar to those obtained by SST k-ε. The particle volume fraction distribution, velocity distribution and temperature distribution in the fluid domain of the drying chamber obtained by numerical simulation with the two turbulence models were similar, and the overall effect is good, which showed that the application of the two turbulence models to the equipment is feasible. The turbulence model of Realizable k-ε converged faster, but the stability of SST k-ε was better. Conclusion: The Realizable k-ε turbulence model is more reasonable to describe three-dimensional flow field of infrared spouted bed.
Publication Date
4-25-2023
First Page
73
Last Page
80
DOI
10.13652/j.spjx.1003.5788.2022.80355
Recommended Citation
(2023)
"Study on the applicability of two numerical models for simulation of infrared turbulent spouted bed,"
Food and Machinery: Vol. 39:
Iss.
2, Article 12.
DOI: 10.13652/j.spjx.1003.5788.2022.80355
Available at:
https://www.ifoodmm.cn/journal/vol39/iss2/12
References
[1] CHANDAN K, KARIM M A, MOHAMMAD U H J. Intermittent drying of food products: A critical review[J]. Journal of Food Engineering, 2014, 121（1）: 48-57.
[2] 石晓微, 刘云宏. 超声—远红外辐射干燥对香蕉片品质的影响[J]. 食品与机械, 2021, 37（1）: 204-209.
[3] LI L, CHEN J, ZHOU S, et al. Quality evaluation of probiotics enriched Chinese yam snacks produced using infrared-assisted spouted bed drying[J]. Journal of Food Processing and Preservation, 2021, 45（4）: 1-14.
[4] MOSES J A, NORTON T, ALAGUSUNDARAM K, et al. Novel drying techniques for the food industry[J]. Food Engineering Reviews, 2014, 6（3）: 43-55.
[5] FENG L, ZHANG M, ADHIKARI B. Effect of water on the quality of dehydrated products: A review of novel characterization methods and hybrid drying technologies[J]. Drying Technology, 2014, 32（15）: 1 872-1 884.
[6] 李晓芳, 刘云宏, 马丽婷, 等. 远红外辐射温度对金银花干燥特性及品质的影响[J]. 食品科学, 2017, 38（15）: 69-76.
[7] 段续, 徐一铭, 任广跃, 等. 香菇分段变温红外喷动床干燥工艺参数优化[J]. 农业工程学报, 2021, 37（19）: 293-302.
[8] 朱凯阳, 任广跃, 段续, 等. 基于BP神经网络预测红外—喷动干燥带壳鲜花生水分比[J]. 食品科学, 2022, 43（11）: 9-18.
[9] 侯志昀, 段续. 任广跃, 等. 喷动床在农产品干燥中的研究进展[J]. 食品与发酵工业, 2021, 47（4）: 275-283.
[10] DEHGHAN M A, PEIGHAMBARDOUST S H, AZADMARD D S, et al. Effect of infrared-assisted spouted bed drying of flaxseed on the quality characteristics of its oil extracted by different methods[J]. Journal of the Science of Food and Agriculture, 2019, 100（1）: 74-80.
[11] MORADI M, AZIZI S, NIAKOUSARI M, et al. Drying of green bell pepper slices using an IR-assisted Spouted Bed Dryer: An assessment of drying kinetics and energy consumption[J]. Innovative Food Science & Emerging Technologies, 2020, 60: 102280.
[12] 段续, 张萌, 任广跃, 等. 玫瑰花瓣红外喷动床干燥模型及品质变化[J]. 农业工程学报, 2020, 36（8）: 238-245.
[13] 周四晴. 基于红外干燥的益生菌浸渍怀山药休闲食品制备技术研究[D]. 洛阳: 河南科技大学, 2020: 5-7.
[14] 马立, 段续, 任广跃, 等. 红外—喷动床联合干燥设备研制与分析[J]. 食品与机械, 2021, 37（2）: 119-124.
[15] 柳鹏飞. 二维及三维矩形喷动床中大颗粒流场特性数值研究[D]. 西安: 西北大学, 2019: 1-3.
[16] MILTNER M, JORDAN C, HARASEK M. CFD simulation of straight and slightly swirling turbulent free jets using different RANS-turbulence models[J]. Applied Thermal Engineering, 2015, 89: 1 117-1 126.
[17] SHIVES M, CRAWFORD C. Adapted two-equation turbulence closures for actuator disk RANS simulations of wind & tidal turbine wakes[J]. Renewable Energy, 2016, 92: 273-292.
[18] 于晓丽, 王树杰, 袁鹏, 等. 两种湍流模型在潮流能水轮机数值模拟中的适用性研究[J]. 中国海洋大学学报（自然科学版）, 2019, 49（2）: 114-120.
[19] 李东耀. 基于Fluent软件的流化床的气固两相流模型研究[D]. 重庆: 重庆大学, 2009: 18-19.
[20] 王敬哲. 气流—喷动床气固两相流动与干燥特性研究[D]. 大连: 大连理工大学, 2017: 55-58.
[21] WU Z H, ARUN S M. Simulation of the hydrodynamics and drying in a spouted bed dryer[J]. Drying Technology, 2007, 25（1）: 62-63.
[22] ZHOU L, HAN C, BAI L, et al. CFD-DEM bidirectional coupling simulation and experimental investigation of particle ejections and energy conversion in a spouted bed[J]. Energy, 2020, 211: 118672.
[23] 谭朝尹. 喷射环流反应器的数值模拟[D]. 杭州: 浙江工业大学, 2012: 15-19.
[24] ANSYS, Inc. ANSYS fluent theory guide.（2018-08-01） [2022-05-22]. https://ansyshelp.ansys.com/account/secured?returnurl=/Views/Secured/prod_page.html?pn=Fluent&prodver=4&lang=en.
[25] MENTER F R. Two-equation eddy-viscosity turbulence models for engineering applications[J]. AIAA Journal, 1994, 32（8）: 1 598-1 605.
[26] MUSA O, ZHOU C, CHEN X, et al. Prediction of swirling cold flow in a solid-fuel ramjet engine with a modified rotation/curvature correction SST turbulence model[J]. Applied Thermal Engineering, 2016, 105: 737-754.